Choose your Automotive paint color for your 1990 Ferrari 599

Restore Your Ferrari Finish In Two Steps

Select Your Ferrari's Color (Step One)

AutomotiveTouchup paint products are custom mixed to perfectly match the color of your 1990 Ferrari 599 using a basecoat/clearcoat system just like factory specs. To insure a proper match, you’ll need to know your vehicle’s color code so you can find it on the chart below. The color code should be located under the hood, by the rear engine cover. Click here for an Ferrari paint code location diagram and label example.

Chip Color Codes Color Description
1990 Ferrari 599 Touch Up Paint | Bianco Avus 100, 231042 100, 231042 Bianco Avus

 

Don't see your color listed?


Call 1-888-710-5192.
We probably have it.

Did you choose the wrong vehicle model?


Did you choose the wrong model? How about the 1990 Ferrari 458 Italia, California, F12 Berlinetta, or FF?  If you're still not sure, take a look at our All 1990 Ferrari Models page.  Or, just go to our page dedicated to Ferrari Touch Up Paint

Why The Two-Step Paint System?

Your 1990 Ferrari 599 is painted at the factory with a high quality basecoat/clearcoat system. This two-step paint system consists of step one, the basecoat, which is your car’s actual color, and step two, the clearcoat, the specially formulated clear paint that protects the base color and provides the luster and deep shine your vehicle came with when new. AutomotiveTouchup products faithfully reproduce your vehicle manufacturer’s basecoat/clearcoat system.

Here's what our customers are saying about our Touch Up Paint:

Tom G, owner of a 1987 Ferrari from Media, PA

Ordered several cans of matching paint and clear coat as well as some sandpaper and sanding block. Packages arrived promptly and the order was correct. Paint matched very well and application was very straight forward. Good final results. As always, the better the prep the better the results. Highly recommended!

Bill T, owner of a 2001 Ferrari from Brentwood, CA

Originally I damaged lower portion of bumper on Ferrari 360 by driving vehicle to far forward on lift that I encountering the stop plates. This actually penetrated the bumper. After removal I decided to repair rather than replace since this is a track car only and the front bumper usually gets dinged up anyway. Once I began repairs I enjoyed it so have spent a bit more time re-learning fiberglass work. So far your products have been amazing for color match and final appearance. The only problem is I have run out of basecoat so have ordered more today. I previously repaired and repainted a 1998 Durango's front and rear bumper at our home in Hawaii after my wife lost a parking battle with a large rock. I will send finished photos after I get additional basecoat, keep up the fine work. Bill Todd, Brentwood CA

Share your touch up story...