Choose your Automotive paint color for your 1992 Audi S3

Restore Your Audi Finish In Two Steps

Select Your Audi's Color (Step One)

AutomotiveTouchup paint products are custom mixed to perfectly match the color of your 1992 Audi S3 using a basecoat/clearcoat system just like factory specs. To insure a proper match, you’ll need to know your vehicle’s color code so you can find it on the chart below. The paint code is normally located in the back compartment panel in the trunk. Click here for an Audi paint code location diagram and label example.

Chip Color Codes Color Description
1992 Audi S3 Touch Up Paint | Brillantschwarz 9004, A2 9004, A2 Brillantschwarz
1992 Audi S3 Touch Up Paint | Tornadorot 9301, G2, LY3D 9301, G2, LY3D Tornadorot

 

Don't see your color listed?


Call 1-888-710-5192.
We probably have it.

Did you choose the wrong vehicle model?


Did you choose the wrong model? How about the 1992 Audi A3, A3 Cabrio, A4, A4 Cabrio, A5, A6, A6 Avant, A8, Cabrio, Cabriolet, Coupe GT, Quattro, RS6, S4, S5, S6, S8, or TT?  If you're still not sure, take a look at our All 1992 Audi Models page.  Or, just go to our page dedicated to Audi Touch Up Paint

Why The Two-Step Paint System?

Your 1992 Audi S3 is painted at the factory with a high quality basecoat/clearcoat system. This two-step paint system consists of step one, the basecoat, which is your car’s actual color, and step two, the clearcoat, the specially formulated clear paint that protects the base color and provides the luster and deep shine your vehicle came with when new. AutomotiveTouchup products faithfully reproduce your vehicle manufacturer’s basecoat/clearcoat system.

Here's what our customers are saying about our Touch Up Paint:

Raul I Ortiz, owner of a 1991 Audi from Truchas, NM

I purchased my touch up kit from you a few weeks ago and tested the color on the inside of the trunk and it looks perfect to me. Now I am tossed between doing all the touch ups myself, which I am not too sure I can handle or take it to a full body shop to make sure it gets done right, and only because I am not a painter or body man.

John K, owner of a 2001 Audi TT Roadster from Carlsbad, CA

I had various results with my touch-up job. The plastic bumper looks fantastic, with a high gloss and great color match. The rear fenders look good on the vertical surfaces, degrading as the surfaces curve around to the trunk and become horizontal. The trunk repaint was not very good. Where the color match is still good, the texture is very grainy and not very glossy. Not much of an improvement over what it looked like before. I'm thinking that sanding between the paint and clearcoats might have helped, or maybe wet sanding after the clearcoat with 1000 rather than 2000. Maybe I didn't take enough off? I followed the directions on your videos, but can't help but thinking there may have been a better way to go about it.

Share your touch up story...